Installation information

INSTALLATION information

Stop the Problem before It Starts.
The Permanent & Professional Way to do it

It is a fact that 1 in 3 baths and showers will leak within a 3 year period, the only time you will know it, is when you see the telltale staining on your ceiling.
The Fit-On fix & seal extrusion can be fitted under or on top of tiling. Installation is very easy when following our step by step instructions. No silicone showing, no large profile of plastic, no up or down movement of the bath or shower. Please note; The Fit-on fix & seal does not replace the need for the bath to be supported by the fixing legs provided by the bath manufacturer.

Bath & Shower. There is a number of ways the extrusions can be used on new or existing bathroom installations.

1. To use the double extrusion system on a new installation and it is going to be a “Built in Bath” to 3 walls, (A) allow 6.5mm min- 10mm max. at each end of the bath size. i.e. 13mm-20mm more then the bath length. This does not apply if fixing to 2 walls only.(B)



          A)                                     (B)

                                                                                Double Extrusion all round the bath
2.    If you have less then 6.5mm at either end of the bath, you can still use the double extrusion by reversing the base extrusion and sitting the bath roll or edge on top of the horizontal leg     , this allows the top extrusion to fit in between the bath and the wall in a gap as small as 1 mm. still providing total support to the bath and use the double extrusion    ,only along the back wall.




3.   If you are renovating an existing bathroom and your existing bath sits up to tiling, you can fit the
top extrusion if there is a minimum gap of 1mm. If your bath sits under the tiling you can fit the shortened version of the extrusion on top of the bath